Configuring Dynamic Endpoint

You can configure Dynamic Endpoint for the Endpoint Profile.

To configure Dynamic Endpoint:

1. You can configure a Dynamic Endpoint in either ways:

   1. Select Asset > Configuration > Endpoint > ProfileList > ADD NEW > Dynamic tab > DYNAMIC CONFIGURATION.

   2. Select Asset > Configuration > Endpoint > ProfileList > DYNAMIC LIST > ADD NEW.
      
      

2. The DYNAMIC CONFIGURATION page is displayed.

   
   Figure: DYNAMIC CONFIGURATION page
   
   

3. Select the Type from the drop-down list, under which you want to add the Dynamic Endpoints. Based on the Type that you select in the DYNAMIC CONFIGURATION page, the subsequent fields are displayed. You can select the following Types:
   
   

4. Click SUBMIT to configure the Dynamic Endpoints.

ACTIONS 

This section explains all the icons displayed on the ACTIONS panel of the DYNAMIC CONFIGURATION page.

 SHOW LIST

Click SHOW LIST to display the LIST table showing all the configured Dynamic Endpoints. For more information, see Viewing Dynamic Endpoint List.