Mapping Field Values

Once the Work Item Fields are created, the Work Item Field Values must be mapped with the Incident Field values.

To map the Field Values:

  1. Click Incident > Configuration > TFS > Configure V-V Mapping. On the CONFIG. VALUE TO VALUE MAPPING List page click ADD NEW.
  2. On the CONFIG. VALUE TO VALUE MAPPING page, enter the required information and click SUBMIT. For more information about the fields on the CONFIG. VALUE TO VALUE MAPPING page, see Field Description.

Figure: CONFIG. VALUE TO VALUE MAPPING page

Field Description

The following table describes the fields on the CONFIG. VALUE TO VALUE MAPPING page:

Field

Description

Incident Fields

All the Incident Fields are listed in the drop-down list. Select the required field name.

Work Item Fields

All the created Work Item fields are listed in the drop-down list. Select the required field name to be mapped to Incident Field.

Value(s)

The Value(s) fields display the respective values of the Incident and Work Item Fields.

Select a value in each field and clickto map the respective field values

Active

Select the check box to activate the Field Values Mapping.

ACTIONS

This section explains all the icons displayed on the ACTIONS panel of the CONFIG. VALUE TO VALUE MAPPING page.

SHOW LIST

Click SHOW LIST to display the LIST table showing all the configured Field Mapping for the selected Tenant.

  • To edit a Field Value Mapping, click the link. Make appropriate changes and click SUBMIT.
  • To display the inactive Field Value Mappings, click the Include Inactive check box.

Note:

When the Field Value Mappings are displayed under the LIST table, the button ADD NEW is displayed on the ACTIONS panel.