Configuring Defect Severity

You can configure the Severity of a Defect for a selected Tenant.

To configure Defect Severity:

  1. Select Change > Configuration > Defect Severity.
  2. On the DEFECT SEVERITY page, click ADD NEW on the ACTIONS panel.
  3. Select the Tenant and type in the new Defect Severity details. For information about the fields on the DEFECT SEVERITY page, see Field Description.
  4. Click SUBMIT. A new Defect Severity is configured.

    DEFECT SEVERITY page
    Figure: DEFECT SEVERITY page

Field Description

The following table describes the fields on the DEFECT SEVERITY page:

Field

Description

DETAILS

Severity Name

Specify the name of Defect Severity.

Sort Order

Specify the sort order for the Defect Severity.

Default

Select this check box to display the Defect Severity as a default selection on other pages of the application.

Active

Indicates the status set for the Defect Severity.

  • If selected, the Defect Severity becomes an available option on the other pages of the application.
  • If not selected, the Defect Severity becomes an inactive value. The inactive Defect Severity values are not displayed in the Defect Severity list on the other pages of the application.

ACTIONS

This section explains all the icons displayed on the ACTIONS panel of the DEFECT SEVERITY page.

SHOW LIST

Click SHOW LIST to display the LIST table showing all the Defect Severity configured for the selected Tenant.

Figure: DEFECT SEVERITY page: List of Defect Severity values

  • To edit a Defect Severity value, click the Severity Name value. Make the appropriate changes and click SUBMIT.
  • To display the inactive Defect Severity values, click the Include Inactive check box.

Note:

When the Defect Severity values are displayed under the LIST table, the ADD NEW action is displayed on the ACTIONS panel. Click ADD NEW to add a new Defect Severity value.

References