Customer Fixed Issues and Known Issues Tahoe SP4 HF09

Owned by Enterprise IT
May 08, 2024
2 min read

 | Previous Versions: << Sierra << Sierra HF01 << Sierra SP1 << Sierra SP1 HF01 << Sierra SP1 HF02 << Sierra SP1 HF03 << Denali << Denali HF01 << Denali HF02 << Denali HF03 << Denali SP1 << Denali SP1 HF01 << Tahoe << Tahoe SP1 << Tahoe SP3 HF01 << Tahoe SP3 HF01 (v1) << Tahoe SP3 HF02<< Tahoe SP3 HF03 << Tahoe SP4 << Tahoe SP4 HF01 << Tahoe SP4 HF02 << Tahoe SP4 HF03 << Tahoe SP4 HF04  << Tahoe SP4 HF05 << Tahoe SP4 HF06  << Tahoe SP4 HF07  << Tahoe SP4 HF08


What's New? | Customer Fixed Issues and Known Issues | Prerequisites | Installation, Configuration, and Upgrade

On this page: Customer Fixed Issues | Known Issues 

Hotfix Merges

Following are the merged releases in Tahoe SP4 HF09:

Resolved Issues 

This section provides details about the fixed customer issues in following modules.

Agentless Discovery

Issue IDIssue DescriptionScenarioResolution

122857

 Flag based Extended SNMP Discovery was not working properly.

Prerequisites:

To enable the Flag based Discovery for SNMP machine, perform the following steps:

  1. Configure SNMP machine and add key="IsSNMPExtendedInfoReq" value="True" /> for Device CDP Info, Interface Info, Net2Media Info, Dot1 Bridge Info and WLCA Access point to view the interface details after the Discovery.

  2. To stop this Discovery partially, set Ping Retry as 99.

Steps:

  1. Select Admin > Advanced > Discovery & Monitoring > Discovery. 

  2. On the DISCOVERY page, click ADD NEW on the ACTIONS panel. 

  3. Select the Tenant and fill in the required details.  

  4. Select the SNMP check box and the SNMP version from drop-down list. 

  5. Specify the protocol details, as required in the fields. 

  6. Click SUBMIT. The Discovery details are configured. 

Flag based Extended SNMP Discovery works appropriately after the resolution.

Known Issues 

This section describes the known issues detected by the Summit Dev and QA team in this release.

Issue IDIssue DescriptionScenario Workaround <if applicable>
127807

Using Report Builder only a few reports like Asset Management, CMDB, or Service Catalog reports can be generated.  

When a Tenant is mapped for example to Knowledge or Call management then the Report Type drop down is displayed as NO DATA. 

  1. Navigate to Admin> Infrastructure > Report Builder. 

  2. Click Filters.

  3. Select the Tenant having only Knowledge Management and Call Management module access. 

  4. Click dropdown Module Name, Report Type and verify if appropriate modules are displayed. 
NA